search
Support
HOMEFAQQ. The arm of the BMA-1GS does not fit into the post.

Q. The arm of the BMA-1GS does not fit into the post.

  • ■ Step 1 Loosen the adjustment screw on the arm side.

    Loosen the adjustment screw on the arm on the side that goes into the post.
    * If the adjustment screw is loosened too much, it will come off, so be careful not to lose it.

    Step 1 Loosen the adjustment screw on the arm side.

  • ■ Step 2 Adjust the orientation of the resin inner ring.

    There is a resin inner ring (C-shaped part) at the part where the support pillar enters.

    Gently turn the inner ring so that it forms a C shape when viewed from the back side of the arm.

    When adjusted to the correct position, you will feel the inner ring fitting into the groove.
    * The inner ring is a necessary part to fix the height of the arm.Please be careful not to remove it.

    Step 2 Adjust the orientation of the resin inner ring.

  • ■ Step 3 Insert the arm perpendicularly to the pillar.

    After inserting it into the pillar, re-tighten the adjustment screw that was loosened in step 1.

    Step 3 Insert the arm perpendicularly to the pillar.

  • Please refer to the video for more information on the above operation.